Vizio K3-T-Series Manuale del Proprietario Scaricare il pdf (Pagina 42)

KANT3

Ant. Input Module

Main RX

Ant 1

KRX3

RX Ant.

KXV3

Sub RX

SA4

Includes C.O.R.

Aux RF

SA1

SA3

Figure 2. Main/Sub Receiver Routing with KXV3 Installed

K3 with KAT3 ATU

The KAT3 internal ATU, which replaces the KANT3 antenna input module, provides a second SO239 antenna

jack (ANT 2). As shown in Figure 3, relay K3 routes either ANT 1 or ANT 2 to the main RF path. The antenna

not routed to the main path (the non-transmit antenna) can optionally be used as the sub receiver’s AUX RF

antenna. This requires that the two antennas connected to the KAT3 be well isolated from each other. If not, the

sub receiver’s carrier-operated relay may turn on during transmit. If this occurs, you must either move the two

antennas farther apart, or not connect the sub receiver to the KAT3.

It may be preferable to connect the sub receiver’s auxiliary RF input to the AUX RF connector on the rear panel.

A well-isolated receiving antenna can then be used with the sub receiver when required. (See CONFIG:KRX3,

for sub receiver antenna setup.)

Ant 1

Ant 2

KRX3

L-Network

KAT3 ATU

Sub RX

SA1

SA2

SA4

Includes C.O.R.

Aux RF

Main RX

Figure 3. Main/Sub Receiver Routing with KAT3 Installed

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 82 83

Nessun commento

Vizio K3-T-Series Manuale del Proprietario Pagina 42